+- Fishing Forum (https://bigfishtackle.com/forum)
+-- Forum: Utah Fishing Forum (https://bigfishtackle.com/forum/forumdisplay.php?fid=386)
+--- Forum: Boats & Motors (https://bigfishtackle.com/forum/forumdisplay.php?fid=171)
+--- Thread: Boat Trailer Side Guides (/showthread.php?tid=1095141)
Boat Trailer Side Guides - GrandpaD 2020 - 04-23-2020
I am thinking about adding side guide polls to my boat trailer.
The purpose is to help speed aligning the boat to trailer when putting the boat back on the trailer.
What are your thoughts about using them?
Can they harm the boat if they are rubbing against it while in toe?
Is it good or bad to have the side bunks touching the bost while in toe?
Mine don't touch if the boat is centered on the trailer.
RE: Boat Trailer Side Guides - wiperhunter2 - 04-24-2020
(04-23-2020, 11:57 PM)GrandpaD 2020 Wrote: I am thinking about adding side guide polls to my boat trailer.
The purpose is to help speed aligning the boat to trailer when putting the boat back on the trailer.
What are your thoughts about using them?
Can they harm the boat if they are rubbing against it while in toe?
Is it good or bad to have the side bunks touching the bost while in toe?
Mine don't touch if the boat is centered on the trailer.
Hey Dale, I see you found your way on the new site, if you want your old username back, send me a PM and I can help you.
IMO I would not have a new boat for long without putting side rails or bunks on the trailer. You should never make them so tight that they will rub your boat and for sure don't have them in contact with the side of your boat during transport. If your boat is touching the side bunks, either push it away from the side or put it back in the water and center it before driving it home.
RE: Boat Trailer Side Guides - Tin-Can - 04-24-2020
(04-23-2020, 11:57 PM)GrandpaD 2020 Wrote: I am thinking about adding side guide polls to my boat trailer.
The purpose is to help speed aligning the boat to trailer when putting the boat back on the trailer.
What are your thoughts about using them?
Can they harm the boat if they are rubbing against it while in toe?
Is it good or bad to have the side bunks touching the bost while in toe?
Mine don't touch if the boat is centered on the trailer.
Dale, I have had side guides on both the boat trailers I've owned since 2004. My current trailer bunks and side guides are all 2x6 Trex decking planks. They won't rot like wood or even pressure treated wood. They are wrapped with indoor - outdoor carpeting. The side guides are mounted to the trailer and are just at the height where the carpet wrapped Trex is about 3 inches below the gunwales, and about 3 inches away from the side of the hull on both sides. I can nose the bow into the end of the trailer and even if it isn't perfectly centered on the bunks at first, it will kind of "bounce" back and forth off the guides and end up centered right up on the bow stand, even in a strong cross wind.
If the guides are well carpeted, and you have an aluminum boat, they shouldn't hurt the boat at all. For either a fiberglass or aluminum boat, be sure any bunk or guide mounting hardware is well countersunk into the supporting material and wrapped well with carpet. Secure the carpet on the outside of the guides or bunks (away from where any boat surface may touch). I used stainless steel 1/4" Hex head self tapping screws about 3/4" long. A bit more $, but they won't rust and break off or leave rust marks on the carpet.