+- Fishing Forum (https://bigfishtackle.com/forum)
+-- Forum: Misc. Fishing Forums (https://bigfishtackle.com/forum/forumdisplay.php?fid=335)
+--- Forum: Rod Building (https://bigfishtackle.com/forum/forumdisplay.php?fid=7)
+--- Thread: How do you straighten a bend ? (/showthread.php?tid=212677)
How do you straighten a bend ? - Dryrod - 07-23-2005
[center][font "Poor Richard"][green][size 4]Have an old bamboo rod which has a bend in the rod's tip section. See picture. Any suggestions on how to straighten this out? Thought about applying steam but I'm afraid that might loosen the adhesive, varnish etc.[/size][/green][/font][/center] [center]
[/center] [center]
[/center]
[signature]
Re: [Dryrod] How do you straighten a bend ? - utwalleye - 07-27-2005
the way I have straightened a fiberglass rod is bend it in the opposite direction and leave it for a while and hit it with a hair dryer. one thing I've noticed about old hexagone 3 piece rods is that they have slight curves to them. the one I have is bent the ones my 2 friends have are also. later chuck
[signature]