+- Fishing Forum (https://bigfishtackle.com/forum)
+-- Forum: Misc. Fishing Forums (https://bigfishtackle.com/forum/forumdisplay.php?fid=335)
+--- Forum: Rod Building (https://bigfishtackle.com/forum/forumdisplay.php?fid=7)
+--- Thread: Good Supply Source (/showthread.php?tid=70692)
Good Supply Source - BearLakeMack - 09-30-2003
[font "Comic Sans MS"][size 3]Anyone know of good sources for components for building ice rods? I have several graphite blanks that I want to wrap up for ice rods. Large eyes are a must! Thanks![/size][/font]
[signature]
Re: [BearLakeMack] Good Supply Source - neveronsunday - 10-01-2003
[#ff0000]Have you checked out the sites nomoose recommended? I have looked about everywhere I can think of in UT with out much selection. In the past, for oversized ice pole eyelets, I have picked up single foot ceramic or carbon spinning guides at the Anglers Inn on I-15 by Hill Field, then sanding the base narrow enough for the small blank. Getting the tippet is another story.... Nomoose said to check out: [/#ff0000][#000000][size 1]try www.mudhole.com or www.jannsnetcraft.com[/size][/#000000]
[#ff0000]On page 63 of the jannsnetcraft catalog are a few.[/#ff0000]
[signature]
Re: [neveronsunday] Good Supply Source - BearLakeMack - 10-01-2003
[font "Comic Sans MS"][size 3]Thanks, NOS. I'll check those sources out![/size][/font]
[signature]
Re: [BearLakeMack] Good Supply Source - aquaman - 10-07-2003
hi blm i have five spinning eyes sitting around that i stripped off a rod a while back your welcome to them if interested let me know
chris
[signature]