07-05-2022, 02:10 AM
(This post was last modified: 07-05-2022, 02:12 AM by Pennyfarmer2.)
![[Image: 20220704-200145.jpg]](https://i.postimg.cc/y3P3N8Zj/20220704-200145.jpg)
![[Image: 20220704-200212.jpg]](https://i.postimg.cc/NL7dX88J/20220704-200212.jpg)
![[Image: 20220704-200227.jpg]](https://i.postimg.cc/qNYwr10R/20220704-200227.jpg)
![[Image: 20220704-200247.jpg]](https://i.postimg.cc/cKwRSZX9/20220704-200247.jpg)
The rear holder is made from a bicycle spoke. There is a small clip that holds it shut.
The release is like a super strong paper clip. I use a inner tube to add clamping power. You just pull the line in further to increase the grip. I was going to use commercial release clips but it seems that is the most expensive part. Plus it is fun to solve the problem for a fraction of the cost.
They cost less than a $1 to make. If I can fine tune the design then it is a benefit to everyone.