Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Willard drive by report
#8
(03-02-2023, 01:51 AM)wiperhunter2 Wrote:
(03-02-2023, 01:02 AM)2knots Wrote:
(03-02-2023, 12:43 AM)wiperhunter2 Wrote: Got up to Willard again today for a look see. No pics but the the ramp on the West side that was out of the water is now covered about two feet to the drop off. The shoreline around the lake is open about 5 to 10 ft depending on the location. It's looking good folks, won't be long now.

I suspect it will be filling at a faster rate now, news said they are starting to let more water out of the reservoirs due to the anticipated run off. I’m ready for some boat time

Typically once the water level starts to rise and the ice starts pulling away from the shore, all it takes is a good strong sustained wind and the ice will be gone.

Just saw the news story again, it’s Dell they’re letting the water out of, probably the rest will follow. Ok come on wind
Reply


Messages In This Thread
Willard drive by report - by wiperhunter2 - 02-24-2023, 10:04 PM
RE: Willard drive by report - by 2knots - 02-24-2023, 10:10 PM
RE: Willard drive by report - by oldguy - 02-25-2023, 10:26 PM
RE: Willard drive by report - by wiperhunter2 - 02-25-2023, 10:37 PM
RE: Willard drive by report - by wiperhunter2 - 03-02-2023, 12:43 AM
RE: Willard drive by report - by 2knots - 03-02-2023, 01:02 AM
RE: Willard drive by report - by wiperhunter2 - 03-02-2023, 01:51 AM
RE: Willard drive by report - by 2knots - 03-02-2023, 01:55 AM
RE: Willard drive by report - by Jmorfish - 03-09-2023, 12:49 AM
RE: Willard drive by report - by Bduck - 03-02-2023, 02:37 PM
RE: Willard drive by report - by wiperhunter2 - 03-09-2023, 12:25 AM
RE: Willard drive by report - by Kent - 03-09-2023, 03:22 AM
RE: Willard drive by report - by wiperhunter2 - 03-09-2023, 03:56 AM
RE: Willard drive by report - by dubob - 03-09-2023, 03:57 PM
RE: Willard drive by report - by oldguy - 03-09-2023, 06:29 PM
RE: Willard drive by report - by SkunkedAgain - 03-09-2023, 04:46 PM

Forum Jump:


Users browsing this thread: 5 Guest(s)