12-14-2006, 01:23 PM
After getting the post as shown in Dryrod's picture bring the thread behind the post, on the tail side of the post. Tug slightly on the thread so the thread puts some tension on the post then make a couple of overlapping wraps around the shank. If I am not sure that is going to secure the post up right I will make another wrap around the post and repeat pulling the thread behind the post and making the overlapping wraps again.
To say it another way. The bacward tension on the post holds it up right. the over lapping wraps of thread keeps the thread tension on the post.
[signature]
To say it another way. The bacward tension on the post holds it up right. the over lapping wraps of thread keeps the thread tension on the post.
[signature]