Wedding Anniversary on Willard 6-15-07

[TubeDude]

[cool][#0000ff]I had to shorten my transducer shaft to make it ride just a couple of inches below the bottom of the tube. I ended up with about 8" of 1/2", plus the fittings. Seems to be about right.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]I can help you with the tool rack if you wanna come over. You need to custom form each connector for the exact tool you are using. The Dremel 1/2" drum sander attachment is great.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]I am going shopping tomorrow for some of the Krylon "Fusion" paints. They are especially designed to bond to plastic...and PVC should qualify. I will test it out and post results on the Tubing board. I will likely have some left over and you can share.[/#0000ff]
[signature]