little help with my double haul

[Dryrod]

[cool][font "Poor Richard"][size 3][green]Hi there birddogwi - this might be a repeat but here is a pic x pic demo by BY LEFTY KREH:[/green][/size][/font][font "verdana,arial,helvetica,sans serif"][size 2]
[font "Poor Richard"][green][size 3]Next to mastering the proper casting stroke, the double haul is the most important tool a fly caster can learn. It permits you to throw a longer line, cast against the wind, and present heavier flies and lines with less effort. Once you master the double haul, you can use it to some degree on almost every cast.[/size][/green][/font]
[font "Poor Richard"][green][size 3]I have observed thousands of fly fishermen in a lifetime of fly fishing, and I now believe that almost every caster uses the double haul incorrectly or at least inefficiently--and that includes many great casters with whom I have been lucky enough to fish.[/size][/green][/font]
[font "Poor Richard"][green][size 3]Before discussing my concept of the proper double haul, I must explain a few important fundamentals of fly casting.[/size][/green][/font]
[font "Poor Richard"][size 3][green]Fundamental I. All casting strokes are divided into two parts: a relatively long motion in which the rod is gradually accelerated and an ending motion with a much shorter and faster speed-up-and-stop of the tip. The speed-up-and-stop is often referred to as a power stroke. Of course, it isn't a power stroke at all; it is a speed stroke. So I call it a speed stroke.[/green][/size][/font]
[font "Poor Richard"][size 3][green]Fundamental II. The shorter the distance the rod tip travels during the speed-up-and-stop, the tighter the loop will be.[/green][/size][/font]
[font "Poor Richard"][size 3][green]Fundamental III. The faster the rod tip accelerates over that final short distance of the speed-up-and-stop and the quicker it stops, the faster the line will travel.[/green][/size][/font]
[font "Poor Richard"][size 3][green]Fundamental IV. Once the line straightens, it begins to fall. The line obtains distance by unrolling. When it has completely unrolled, it will go no farther.[/green][/size][/font]
[font "Poor Richard"][size 3][green]Fundamental V. Line control is the most important element of good casting. You must prevent slack from entering the system during the cast.[/green][/size][/font]
[font "Poor Richard"][green][size 3]You can observe these fundamentals by conducting your own interesting experiment with just four casts.[/size][/green][/font]
[font "Poor Richard"][green][size 3]1. Make several false casts, then sweep the rod forward near the end of the casting stroke in a relatively long speed-up-and-stop and you will see the line develop a large loop.[/size][/green][/font]
[font "Poor Richard"][green][size 3]2. Make another cast, but this time make a much shorter stroke at the end of the casting stroke. Watch as the line forms a tighter loop.[/size][/green][/font]
[font "Poor Richard"][green][size 3]3. Make another cast with a short stroke (to form a small loop) but during the speed-up-and-stop, move the rod tip rather slowly and don't stop quickly. You will see a small loop form, but it will not go far.[/size][/green][/font]
[font "Poor Richard"][green][size 3]4. Finally, make another cast, but this time, move very rapidly over that short distance at the end of the cast and make the rod tip stop as abruptly as possible. Watch as the line forms into a small, tight loop. The swiftness of the stroke and abruptness of the stop causes the line to travel much farther.[/size][/green][/font]
[font "Poor Richard"][green][size 3]It is vital to understand that the more swiftly the rod tip moves through that very short final distance and the quicker the stop, the tighter the loop and the farther the cast will unroll before it begins to fall. A tight loop made with a quick stop directs more energy toward the target. If you understand these three factors, you can see why a single or double haul permits you to make longer casts.[/size][/green][/font]
[font "helvetica,sans-serif"][black][size 2]The rod tip should start low and stay low on longer casts. Note that both hands are close together at the start.[/size][/black][/font]
[font "helvetica,sans-serif"][black][size 2]As the rod rises and loads, your line-hand follows your rod-hand and they are kept the same distance apart.[/size][/black][/font]
[font "helvetica,sans-serif"][black][size 2]The haul is short (inches) and hardly noticeable. Compare the distance between steps 2 and 3.[/size][/black][/font]
[font "helvetica,sans-serif"][black][size 2]The forward cast begins and your rod-hand and line-hand stay at equal distance apart until the haul is made during the speed-up-and-stop.[/size][/black][/font]
[font "helvetica,sans-serif"][black][size 2]The short haul is made with both hands stopping at the same time.[/size][/black][/font]
[font "helvetica,sans-serif"][black][size 2]As soon as both hands stop, the line can be released or controlled as it shoots to the target.[/size][/black][/font] [/size][/font]
[signature]