03-13-2011, 02:10 PM
Well the project has moved on slower than I had thought, especially the floor. However I did settle on a lower floor, not in the side water line seam. Idid put a lenfth of 1/2 pvc under the floor along with the fuel line running from the tank under the front seat.
[inline "GEDC0566 (Small).JPG"]
I also have the battery in front under the same seat. It fits tight when slide the seat back in to it's original placement. Im hoping that will secure it.
I am not sure how I will put the rod holders in yet. I want to run some supports for the to of the boat to the flooring, just not sure how yet.
[inline "GEDC0565 (Small).JPG"]
The next item is the front seat. I have the support tubing from the table in a camper I had stripped, which I will cut down to the appropriat hiegth and mount one of the swivle seats on it. It will pull out of the floor mount like it does in the camper for traveling if it needs to.
[inline "GEDC0564 (Small).JPG"]
So thats how the story goes. Not sure ow I will secure the floor yet so any suggestions on any thing I have or need to do is appreciated and thanks for the suggestions so far.
[signature]
[inline "GEDC0566 (Small).JPG"]
I also have the battery in front under the same seat. It fits tight when slide the seat back in to it's original placement. Im hoping that will secure it.
I am not sure how I will put the rod holders in yet. I want to run some supports for the to of the boat to the flooring, just not sure how yet.
[inline "GEDC0565 (Small).JPG"]
The next item is the front seat. I have the support tubing from the table in a camper I had stripped, which I will cut down to the appropriat hiegth and mount one of the swivle seats on it. It will pull out of the floor mount like it does in the camper for traveling if it needs to.
[inline "GEDC0564 (Small).JPG"]
So thats how the story goes. Not sure ow I will secure the floor yet so any suggestions on any thing I have or need to do is appreciated and thanks for the suggestions so far.
[signature]