06-29-2011, 11:55 PM
[quote maitopoika]
So if that was it, how do I figure out where the water is getting through? I can't really figure out how the engine gets air. I see the air intake above the carb but how does air get into the motor cover?
I will run sea foam from now on either way.[/quote]
I'm not really sure about water getting into your gas unless it was condensation but air can get into the gas at the fittings or at the squeeze bulb if the clamps are loose. If it happens again try squeezing the bulb and see if it starts running better, if it does, either tighten the clamps or replace the entire line including the squeeze bulb.
[signature]
So if that was it, how do I figure out where the water is getting through? I can't really figure out how the engine gets air. I see the air intake above the carb but how does air get into the motor cover?
I will run sea foam from now on either way.[/quote]
I'm not really sure about water getting into your gas unless it was condensation but air can get into the gas at the fittings or at the squeeze bulb if the clamps are loose. If it happens again try squeezing the bulb and see if it starts running better, if it does, either tighten the clamps or replace the entire line including the squeeze bulb.
[signature]