Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My UL tube project...
#57
I went down to my local "pond" to test out the new boat. I did my best to try to fall out and I failed. I inflated it on shore then hopped in and it immediately tempered - lost pressure due to cooling down. In this less than tight state it was a bit wobbly with how high I sit. Felt a bit like balancing on a ball side to side. Front to back was fine. A quick few breaths to tighten the skin and back in the drink.

MUCH better. Definitely not as solid feeling as my Fish Cat but that's to be expected because of the way the seat is attached to the "U". It does allow some roll, but I think it won't be hard to get used to. Feels kinda like sitting in a canoe or kayak, especially at first when the pressure dropped. Still, no risk of actually barrel rolling.

I'm WAY out of the water - probably A good 3", pretty much what I had designed for. I can make do with pants waders, no chest waders required.

Anyway, photos:

[Image: 8691279068_4d6e9c2302_b.jpg]

[Image: 8690163763_eb4ce3fb7c_b.jpg]

[Image: 8690155155_18676dc0c0_b.jpg]

[Image: 8691269660_7034f78385_b.jpg]

[Image: 8690146743_d4b5e1c92f_b.jpg]

I made some fly casting motions while I was at it and it was a no-drama affair - not that I had expected any.

I'll have to take my gear next time I hit the "pond". Wink

_SHig
[signature]
Reply


Messages In This Thread
My UL tube project... - by SHigSpeed - 11-20-2010, 02:50 AM
Re: [SHigSpeed] My UL tube project... - by SHigSpeed - 04-29-2013, 04:46 AM

Forum Jump:


Users browsing this thread: 28 Guest(s)