|
Latest Rod Build
|
11-07-2013, 01:26 AM
my equipment is nothing special. just a couple rod supports made with some 1x6 screwed together in an L shape with a v notch cut into them. Then I glued felt in the v notch to protect the rod. I just hand turn the rods. For drying I bought a low rpm motor and a chuck made from pvc and plastic screws. I use the rod supports as well while drying. Very simple set up but I'm hoping to upgrade and get a power wrapper setup.
[signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Latest Rod Build - by flyfish_88 - 11-06-2013, 04:11 AM
Re: [flyfish_88] Latest Rod Build - by hooknhunter - 11-06-2013, 12:51 PM
Re: [flyfish_88] Latest Rod Build - by cpierce - 11-06-2013, 12:57 PM
Re: [flyfish_88] Latest Rod Build - by idahopanfish - 11-06-2013, 01:10 PM
Re: [idahopanfish] Latest Rod Build - by flyfish_88 - 11-07-2013, 01:26 AM
Re: [flyfish_88] Latest Rod Build - by flygoddess - 11-07-2013, 01:44 AM
Re: [flygoddess] Latest Rod Build - by flyfish_88 - 11-07-2013, 06:02 AM
Re: [flyfish_88] Latest Rod Build - by CatchermanB - 11-12-2013, 11:21 PM
Re: [CatchermanB] Latest Rod Build - by flyfish_88 - 11-13-2013, 02:17 AM
Re: [flyfish_88] Latest Rod Build - by flygoddess - 11-13-2013, 02:39 AM
|
