07-03-2014, 03:22 PM
Slow and easy would be my guide in this. I'd soak the rods in a mild solution of detergent for a good amount of time.
Buy an 8' section of PVC in the smallest diameter that will hold the largest line guide, plus an end cap. Put the rods in, set the PVC on an incline where it is out of the way and fill it with the solution of your choice. Cover with a loose cap of cellophane in case there is any outgassing. Check after a week and replace the solution if the job isn't done yet. Scrub with a soft brush when the algae has softened or dropped off.
[signature]
Buy an 8' section of PVC in the smallest diameter that will hold the largest line guide, plus an end cap. Put the rods in, set the PVC on an incline where it is out of the way and fill it with the solution of your choice. Cover with a loose cap of cellophane in case there is any outgassing. Check after a week and replace the solution if the job isn't done yet. Scrub with a soft brush when the algae has softened or dropped off.
[signature]