Bad Wheel Bearings or Flat Tires?

[Old_Coot]

[quote BearLakeFishGuy] ... suggest putting in the inside bearing and seal ... It is the only way to go. I had to replace a bearing and it was much easier to just swap out the hub with the inside seal and bearing in place than trying to swap out a bearing on the old, messy hub. ... You really don't want to be trying to tap in grease seals when the wind/sand is blowing out in WY. Just stick the new hub in place and put in the outer bearing, nut, and pin and you are good to go. I use channel-lock pliers to remove my bearing buddy instead of a mallet/screw driver.[/quote]

Excellent advice Scott. Thanks.
[signature]