Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
auger issues
#2
Where is your hometown? It could be the float in the carb stuck so it's not shutting off the fuel flow when the bowl is full. Likely needs a good carb cleaning. A small motor repair shop should be able to fix you up without too much expense. Or if your handy get some carb cleaner and spray the fuel passages so it melts the gum out. I usually end up only accomplishing half the job and have to redo it a couple trips later when I've done it myself, but I probably don't get in the right spots. I should just take mine in but I don't plan that far ahead. Good luck with it. J
[signature]
Reply


Messages In This Thread
auger issues - by leakyboat - 01-14-2016, 03:36 AM
Re: [leakyboat] auger issues - by SkunkedAgain - 01-14-2016, 04:42 AM
Re: [SkunkedAgain] auger issues - by wiperhunter2 - 01-14-2016, 02:48 PM
Re: [wiperhunter2] auger issues - by SkunkedAgain - 01-14-2016, 10:35 PM
Re: [SkunkedAgain] auger issues - by Therapist - 01-15-2016, 12:13 AM
Re: [Therapist] auger issues - by SkunkedAgain - 01-15-2016, 12:54 AM
Re: [leakyboat] auger issues - by klam - 01-14-2016, 06:00 AM
Re: [leakyboat] auger issues - by utwalleye - 01-14-2016, 09:05 AM
Re: [leakyboat] auger issues - by BULLOCK9 - 01-14-2016, 01:27 PM
Re: [leakyboat] auger issues - by leakyboat - 01-16-2016, 06:07 PM
Re: [leakyboat] auger issues - by mtncat1 - 01-17-2016, 03:27 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)