09-04-2016, 12:22 AM
Here's something I've been wanting to work on and I finally did!
All i did was remove some material from the nose and tail of the lure to make room for the props. Then squeezed the front and rear eye so i could pass the prop through,then opened up the eyes to secure the props. Also removed the lip of the lure and swapped hooks for singles.
One thing i was worried about was the front and rear eye from pulling out! I gave it a good pull and seems to hold,I'm not sure if the eyes are connected by one solid wire but i'm thinking it may be? might end up cutting one open
Video is on the way working on it on my youtube channel Paulpro PP
[signature]
All i did was remove some material from the nose and tail of the lure to make room for the props. Then squeezed the front and rear eye so i could pass the prop through,then opened up the eyes to secure the props. Also removed the lip of the lure and swapped hooks for singles.
One thing i was worried about was the front and rear eye from pulling out! I gave it a good pull and seems to hold,I'm not sure if the eyes are connected by one solid wire but i'm thinking it may be? might end up cutting one open
Video is on the way working on it on my youtube channel Paulpro PP
[signature]
